Wicked lasers S3 Krypton Series Manuel d'utilisateur télécharger pdf (Page 10)

User’s Manual & Laser Safety Guide | 13

S3 Krypton Series | 12

WWW.WICKEDLASERS.COM

How To Use The SmartSwitch™ 2.0

SmartSwitch™ 2.0 Codes:

After unlocking your laser, you can select among the active modes by using one of these following codes when

pressing the button:

▪ A long hold (holding down briey for less than a second) cycles between high power and low power.

▪ A short hold cycles Strobe mode to Continuous Wave mode.

▪ Clicking 3 times within 2 seconds goes into SOS mode.

▪ From SOS mode, one quick press will change it into Beacon mode.

▪ From Beacon mode, one quick press will change it to low power Strobe mode.

▪ Holding the switch for 3 seconds will go to Tactical Hibernation mode. The middle LED will be

ashing to indicate this.

How To Use The SmartSwitch™ 2.0

The following 9 modes are enabled by using

the SmartSwitch™ 2.0:

▪ Strobe Mode (Hi / Low)

▪ Continuous Wave (Hi / Low)

▪ SOS (Hi / Low)

▪ Beacon (Hi / Low)

▪ Tactical Hibernation Mode

Once the power is on, the user can toggle between

the di󰮏erent active modes all available in low

power and high power: Strobe, Continuous wave,

SOS and Beacon mode with a few simple clicks.

There is also the Tactical hibernation mode which

allows you to shut o󰮏 the laser and quickly re-

enable it with the last setting it was on.

To summarize: This is the rst code you should remember three short holds + two

long holds (holding the button down briey for less than 1 sec.) will let you unlock the laser.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 18 19

Pas de commentaire

Wicked lasers S3 Krypton Series Manuel d'utilisateur Page 10